Excavation Calculator
Excavation volume for a rectangular or circular pit, shaft, trench or footing, with optional swell and truck loads.
Runs on your device Processed locally in your browser. Nothing is uploaded.
Concrete volume and order volume for slabs, footings, walls, beams and columns, with overage and optional bags.
Quantity estimate only. A nominal 1:1.5:3 ratio is not an engineered M20/design-mix or strength guarantee. Artwork is illustrative. This is an independent reference prototype, not a production engine or certified engineering design.
Results are provided for guidance. Check them against the applicable rules and your professional judgement before relying on them.
Unit conversions are exact: 1 mm = 0.001 m, 1 cm = 0.01 m, 1 inch = 0.0254 m and 1 foot = 0.3048 m, so 1 ft³ = 0.028316846592 m³ and 1 yd³ = 0.764554857984 m³ exactly. Imperial and metric inputs that describe the same member give the same volume.
The rule is exact first, round once: every volume is kept at full precision and rounded only for display. Choose 2, 3 or 4 decimal places to set both the displayed volume precision and the accepted precision of the overage percentage; unit-converted measurements retain the extra internal precision needed for exact conversion.
Overage is your estimating allowance, not a rule. It covers spillage, uneven formwork or over-excavation, and how much is sensible depends on the job, so the percentage is always shown with the result.
Why yield, not bag weight? Bags of the same weight can yield different volumes depending on the product, so this calculator never guesses a yield from weight. Use the figure printed on your bag.
If any dimension, converted to metres, is larger than 100 m, the calculator still gives a result but shows a warning — this usually means the wrong unit was selected.
This calculator gives concrete volume only. It does not calculate reinforcement (rebar), mix design or the cement/sand/aggregate split, cost, or a bill of quantities (BOQ).
A 5 × 4 × 0.15 m slab, 1 member, with a 5% overage allowance:
| Input | |
|---|---|
| Member type | Slab |
| Unit | m |
| Length | 5 |
| Width | 4 |
| Depth / thickness / height | 0.15 |
| Same-size members | 1 |
| Overage allowance % | 5% |
| Result | |
| Concrete to order incl. overage (m³) | 3.150 |
| Concrete to order incl. overage (yd³) | 4.12 |
| Concrete to order incl. overage (ft³) | 111.24 |
| Net geometric volume (m³) | 3.000 |
| Overage allowance | 5% |
| Overage volume (m³) | 0.150 |
| Same-size members | 1 |
Slabs, footings, walls, beams, rectangular columns and general rectangular volumes all use length × width × depth. Circular columns use π × (diameter ÷ 2)² × height.
An editable estimating allowance applied to the net geometric volume to give an order volume. It defaults to 0% and can be set from 0 to 50%. Common practice varies by job and supplier, so choose the allowance that fits your project.
Enter the yield per bag printed on your pre-mixed product (in litres, m³ or ft³). The calculator divides the order volume by that yield and rounds up to a whole bag. Leave the yield blank to skip bags.
No. One unit applies to every dimension of a member. Switching the unit converts the values already entered, so you can type in one unit and read the result in another.
No. This is an estimation aid, not a certified bill of quantities. Local codes, site conditions, mix design, wastage and measurement rules vary by project — verify quantities before purchase or construction, and confirm the final figures with a licensed engineer, architect or professional quantity surveyor.